BOMANN cb 597 Bedienungsanleitung Seite 24

GB
• Please read these operating instructions carefully and keep them in a
safe place.
• Before using for the fi rst time, boil fresh water at least twice in the appliance.
Use only water without any additives or ingredients.
1. Place the machine on a fl at surface.
2. Open the kettle with the button in the handle. Fill it with water. Fill only up
to the maximum mark (MAX). You can check the level on both sides of the
appliance with the water level display.
3. Close the lid.
4. Place the kettle fl ush on the base.
5. Electrical connection
• Check whether the electrical voltage that you intend to use is the same as
that of the machine. Details are to be found on the label on the base.
• Only connect the machine to a properly installed 230 V, 50 Hz safety
socket.
6. Switch on the kettle by pressing the switch. The control lamp in the switch
lights up.
7. When the water is boiling the kettle switches itself off automatically unless
you press the switch to interrupt or stop the water from boiling. Disconnect
the kettle from the mains. When pouring the water out, keep the lid closed.
Danger of scalding!
• Always pull out the plug from the socket before cleaning!
• The exterior of the machine should be cleaned, if necessary, with a slightly
damp cloth without additives.
• For cleaning purposes the lime fi lter can be removed by pulling upwards by
the tab. Remove the lime deposits by rinsing the fi lter under running water.
• The frequency of the decalcifying operation depends on the hardness of the
water and on how often the appliance is used.
• If the machine switches off before the water boils, it probably needs to be
decalcifi ed.
• Please do not use vinegar but a commercially available decalcifi cation agent
on the basis of citric acid. Only use the quantities stated in the instructions.
24
6....-05-WK 2900 24
First Use of the Machine
Use
Cleaning
Decalcifi cation
07.12.2004, 10:21:49 Uhr