Clatronic BFS 3616 Bedienungsanleitung Seite 32

• Check the delivery scope for completeness.
• Check the appliance for any transport damage in order to
prevent hazards.
• In case of incomplete delivery or damage, do not use the
appliance. Return it to the dealer immediately.
NOTE:
There may be dust or production residue on the appliance.
We recommend cleaning the appliance as described under
"Cleaning".
Instructions for Use
CAUTION:
• Only use the appliance for disinfecting baby bottles
including accessories or other boil-proof items. Follow the
manufacturer's instructions for each respective item.
• Never turn on the appliance without water.
• Fill the container with at least 80 ml of water.
• The more water you pour in, the longer the disinfection
process.
• Do not open the lid before the disinfection process has
been finished. That is the only way to ensure that germs
will be killed.
NOTE:
• We recommend using only distilled water in order to
prevent calcification of the appliance. If you do not have
distilled water, use fresh tap water only.
• Clean all items to be disinfected thoroughly before
disinfecting.
Electrical connection
The main switch is on the rear of the device.
1. Set the main switch to " " position, otherwise the device
can accidentally start.
2. Check whether the electrical voltage that you intend to use
is the same as that of the machine. Refer to the rating plate
on the container for detailed specifications.
3. Connect the mains cable to a properly installed earthed
wall outlet.
Assembly
1. Insert the rod into the cavity in the center of the bottle
basket. Turn the rod clockwise until it locks into place.
2. Slide the bottle holder and the tray for small parts onto the
rod.
3. Place the assembled rack in the container.
4. Install the appliance on a flat working surface.
On/Off
• Switch the device with the main switch on the rear of the
device on " " and off " ".
• Use the Power switch (10) to switch the device on.
32
CAUTION:
If the operating control lamp lights up when switching the
device on, then it is directly operable. Heating starts immedi-
ately, even if the container is empty.
Prior to first-time use
Operate the appliance with installed accessories once without
items to be disinfected. To do so, follow the instructions below.
Use
1. Make sure the mains plug is not connected to a wall
socket. Set the main switch to " " position.
2. Fill the container with distilled water.
3. Place the baby bottles with the opening facing downwards
in the bottle case. Place the dummy or other small parts on
the tray.
4. Place the assembled rack with the items to be disinfected
in the container.
5. Place the lid on the container.
6. Connect the appliance to a properly installed earthed plug
socket.
7. Set the main switch to " " position.
8. If the operating control lamp does not light up, turn on the
appliance using the power switch. The control lamp will
indicate the operating mode.
NOTE:
• When the water has evaporated, the appliance will turn
off automatically. The control lamp turns off.
• The operating time depends on the amount of water
poured in.
• To cancel the disinfection process, set the main switch to
" " position.
After disinfection
WARNING: Risk of scalding and burning!
• Let the appliance cool down for at least 5 minutes before
opening the lid carefully!
• Remove the disinfected items only with the gripper. The
items are very hot!
NOTE:
• Use the disinfected items immediately after removing
them from the appliance. Otherwise they will have to be
disinfected again.
• If you keep the lid of the appliance closed, the items in the
container remain disinfected for a maximum of 3 hours.
After that they will have to be disinfected again, no matter
whether the appliance had been opened or not.
• Set the main switch to " " position.
• Disconnect the mains plug from the wall socket.
• Shake off residual water on the items.
• Pour the remaining water out of the container.