Herunterladen Inhalt Inhalt Diese Seite drucken

Preparing The Appliance; Using The Appliance; Emptying The Dust Container And Cleaning The Filter - Melissa 640-277 Anleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 29

PREPARING THE APPLIANCE

1. Attach the hose (11) to the
appliance by fitting the hose
connector (13) into the hose
port (9) at the upper part of the
appliance until it clicks into place.
2. Put the two parts of the tube (14)
together by pushing the thinner
end of one tube into the thicker
end of the other tube. Fix the tube
to the hose nozzle (12).
3. Install the floor nozzle (15) or the
joint nozzle to the end of the tube.
Please note that both nozzles may
also be installed directly on the
hose.
4. Check that the dust container (1)
and HEPA filter (6) are assembled
correctly (see section on Cleaning
filters and emptying the dust
container, below).

USING THE APPLIANCE

1. Unwind the cord (3).
2. Connect the appliance.
3. Press the On/off button (2) to
switch the appliance on and off.
4. Suction strength can be regulated
by opening and closing the air
vent (18) on the handle.
o When the vent closes full
suction is achieved. This is the
normal setting.
o When the vent opens, more air
is allowed in, reducing suction
power at the floor nozzle.
This function is for cleaning
curtains and other light items
which can get sucked into the
nozzle.
5. The floor nozzle brushes have two
settings, which can be selected
using the two switches (16 and 17).
o When cleaning hard surfaces
(wooden floors, stone floors,
tiles, linoleum, etc.), the nozzle
brushes should be extended.
o When cleaning carpets and
rugs, the brushes should be
retracted into the nozzle.
6. Always turn off the appliance using
the on/off button, and unplug it,
when you are finished with it.
• IMPORTANT! If the suction
strength of the appliance is
reduced, the nozzle, hose or dust
container inlet may be blocked, or
the filters may be blocked or dirty.
Stop using the appliance if this is
the case, as this will damage the
motor. Immediately remove the
cause of the blockage or clean the
filter.
EMPTYING THE DUST CONTAINER
AND CLEANING THE FILTER
This appliance is not equipped with a
dust bag. The dust/dirt is sucked into
the transparent dust holder instead.
Once the dust is in this container, it
whirls around so that it does not block
suction. The air sucked in is cleaned
by means of a washable filter in the
dust container.
We recommend that you empty the
dust container and clean the filter
every time you use the vacuum
cleaner, and if the dust container is
full.
25

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis