Kärcher k 55 Originalbetriebsanleitung Seite 8

11 Scope of delivery K 55 pet:
Brush roller with cleaning cover (animal
hair brush), can be interchanged
12 Unlocking button for the changeable
brush
13 Telescopic strut, adjustable height
14 Turning handle
15 Handle
16 Charger with charging cable
17 Wall mount with fasteners
Installing the wall unit
Illustration
The wall mount is to be used for storing the
appliance and the charger.
Mount the enclosed wall mount at an
easily accessible point near to a socket -
the fastener is enclosed.
Insert the brush roller
Illustration
The brush roller has not yet been inserted in
the appliance at the time of delivery. Please
insert the brush roller before starting the ap-
pliance.
Turn the casing.
Insert the brush roller in the side-intake.
Press in the holder of the brush roller into
the intake and check that it is sitting
properly.
Installing the telescopic handle and
the handle and adjusting the height
Illustration
The telescopic strut consists of 3 parts.
While assembling it, make sure that the
parts lock into each other.
Insert the handle on the longer strut with
turning handle.
Insert together the longer and shorter
struts; while assembling it, press the
locking button.
Insert the entire strut with the locking but-
ton into the joint on the appliance.
Loosen the handle and pull out the strut
to the desired working height; turn the
4
8 English
Deutsch
handle to the correct position and tighten
using the turning handle.
Inserting and charging the battery
Illustration
The battery has not yet been inserted in the
appliance at the time of delivery. Please in-
sert the battery before commissioning the
appliance.
Remove the rechargeable battery from
its packing.
Insert the battery into the intake until it
locks.
Charge the battery: The battery can be
charged when it in the applianced or re-
moved out of it. Note: The following sec-
tion describes the charging process
when the battery is in the appliance.
Insert the charger delivered with the ap-
pliance into a proper socket.
Important note for charging: Always
switch off the appliance otherwise the
battery will not get charged.
Insert the charging cable in the charging
box at the battery.
When the operating display glows, it
means the charging process has started.
The charging time for an empty battery is
approx. 14 hours.
Note: If the operating display does not
glow, switch off the machine because
otherwise the charging process cannot
start.
Remove the plug from the charger sock-
et and disconnect the charger from
mains power after you have finished
charging.
Operations
Starting the work
Illustration
Switch on the appliance; press the on/off
foot switch to do so.
Move the appliance forward and back-
ward to clean it.