Care And Maintenance - Kärcher CW50 Betriebsanleitung

English
5.1 Exchanging the paper filter bag <Figure 7>
• Depress the cover fastener and remove cover.
• Push the filter bag catch to the left until it is possible to pull the
filter bag off the connection piece.
Assembly:
• Insert the narrow end of the support card into the holder.
• Push the filter bag catch to the left and guide the support card
upwards over the connection piece until it slots in.
• Replace the cover.
Please note: If the cover does not close, check whether the filter
bag has been inserted properly.
5.2 Exchanging the safety filter <Figure 8>
After exchanging the filter bag approximately 20 times, exchange
safety filter.
• Press cover fastener and remove cover.
• Lift the red locking device and pull out the safety filter.
Assembly:
• Lift the red locking device and insert the safety filter.
Please note: If the cover does not close, check whether the filter
bag has been inserted properly.
5.3 Exchanging the exhaust filter <Figure 9>
After exchanging the filter bag approximately 20 times, exchange
the exhaust filter.
• Push the exhaust filter off the housing and withdraw.
Assembly:
• Insert new filter.
5.4 Exchanging the brush strip <Figure 10>
• Unscrew the brush head cover. Turn the brush so that the
brush strip can be pushed or pulled through the opening.
Assembly:
• Push home the new brush strip and screw the cover on again.
12

5. Care and maintenance

5.956-722
Figure 7
Figure 8
Figure 9
Figure 10