Troubleshooting - Texas RT 5000 Gebrauchsanweisung

devices 1 at the sides of the cutting head, and remove the
cutting head cover 2 (fig. 12). Remove the used thread coil
and put in the new coil 3 such, that one end of the thread
comes out of each outlet at the sides of the cutting head
(fig. 13). Please take care that the spring 4 is properly
seated under the thread coil. Finally, close the cover by
pushing it in its seat. Both locks must properly engage.
12. Trouble shooting
• Trimmer does not work: Check power supply (e.g. by
testing on another socket or by means of a voltage
tester). Should it still not work, although the socket is
o.k., send it undismantled to an authorised service
station for repair.
• Cutting line disappears into spool: Remove spool
(acc. to point 11), pull end of line through the metal outlet
and reinsert spool. In case nylon line is used up insert a
new spool with line.
Do not make any other repairs on your own; have your
trimmer checked and repaired by an authorised dealer.
13. Storing
• Clean the unit thoroughly, especially the cooling air
slots on the motor housing.
• Do not use water to clean the device.
• Store trimmer indoors in a dry, high or locked place
and keep out of reach of children.
14. Repair saervice
Repairs to electric power tools should only be carried
out by a specialised electrician.
Texas
Andreas Petersen Hojby ApS
Knullen 2
DK – 5260 Odense S
Tel.: 0045 - 63-9555-55
Fax: 0045 - 63-9555-58
GB-4