Programming The Transmitter; Wing Model Programming; Servo Reverse Function - Nine Eagles J6 Bedienungsanleitung

MIX: flashes while programming, when the mixer is not active / MIX is display when the mixer is active.
The 4 bars on the screen, are the trim indicators and show the position of the trims.
On the channel indictor, you can see which channels are activated
1: aileron channel
2: elevator channel
3: throttle channel
4: ruder channel
5: gyroscope/landing gear
6: pitch channel/ flaps
Switching on the transmitter
Place every switch in the normal position. (this means place to the back , away from the pilot) and switch on the transmitter. The LCD screen
displays the actual parameters. There are 3 kinds of parameters that you can set:
General parameters, advanced parameters and special parameters. You can find an overview below. In general you -Press the A-button in order
to go to the general menu.
- press the A & B button simultaneously in order to go to the advanced menu.
Airplanes & Gliders
Functions
Servo reverse
General parameters
Dual Rate
Wing mixer (Delta, V-Tail, Flaps/ailerons)
Throttle curve
Gear Speed
Trims
Advances parameters Model Type selection
Range Test
Wireless copy
Model type selection
Advanced parameters
Swashplate type
Range Test
Wireless copy
A:Control of radio controlled airplanes
There are several possibilities to use this transmitter in combination
with model airplanes, gliders,...
Modeltype, channel reverse, dual rate, wing mixers, curves, trims,.....
can all be setup. Below you'll find an overview of all switches
Model Type setup Page 5
Description Steps to follow
This function offers two 1. Turn on the transmitter
possibilities: 2. Simultaneously press the A-button and B-button for one second. On the LCD
Airplanes or Helicopters
3. Turn the D-Knob until the ""Mode""-icon and the
""model type""-icon (helicopter or airplane) flash together on the LCD screen"
4. Next press the C-button or the A-button. The Modeltype icon keeps flashing.
5. Select the desired model type (helicopter or aeroplane), by turning the D-Knob.
6. Press the C-button to confirm your choice and its corresponding parameters
7. Press the B-button to go back in the menu.
J6 transmitter
screen the "MODE" -icon and the "Modeltype" Icon" (helicopter or airplane) will
start flashing.
helicopters
Page
P4
P4
P4
General parameters
P5
P5
P6
P6
P9
P9
Special Functions
Functions
P6
3D Switch safety
P6
Throttle hold Switch safety
P9
Reset
P9
Communication protocol
Stick calibration
Factory settings
Trainer function
(separate receiver required)
Functions
Servo reverse
Dual Rate
CCPM Mixer
General Mixers
Throttle curve
Gyro sensitivity
Throttle Hold
Trims
Instructions
The model type option includes two options:
Airplane or helicopter.
An alteration of the model type will modify all parameters of
the current model to the default factory settings. So be careful
when using this function. If you are not sure, do NOT press
the C-button, in order to avoid replacing the settings by default
values. After changing the model type, it is recommended to
restart the transmitter, in order to make sure that your changes
have been saved.
copyright © 2012 BMI
Page
P6
P7
P7
P7
P9
P9
P9
P9
Page
P9
P9
P10
P10
P10
P10
P10