Suspension; Dropout / Derailleur Hanger; Shock; General Recommendation M4-M8 - Propain Rage Carbon Bedienungsanleitung

12

Suspension

Bearing
1)
2)
3)
4)

Dropout / Derailleur hanger

The dropout / derailleur hanger needs to be tightened using 12 Nm
/ 8,9 ft lb.
The rear X-12 axle needs to be tightened using 10-16 Nm / 7,38-
11,8 ft lb.

Shock

The M8 bolt screws of the shock need to be tightened using 18 Nm
/ 13,28 ft lb.
Tightening torque
25 Nm / 18,44 ft lb
25 Nm / 18,44 ft lb
9 Nm / 6,64 ft lb
25 Nm/ 18,44 ft lb

General recommendation M4-M8

You can find general recommendations in the following
table in case there are no other instructions on spare
parts. Propain also recommends using Loctite 243 (me-
dium) to secure those screws.
Size of the screw
M4
M5
M6
M8
Shock
The Rage Carbon frame is compatible with most of the shocks avail-
able on the market (with the correct length and travel). Neverthe-
less, there are exemptions which is why Propain always recom-
mends a check of compatibility when installing a new shock into the
bike.
i
Tightening torque
3 Nm / 2,21 ft lb
6 Nm / 4,42 ft lb
9 Nm / 6,64 ft lb
18 Nm / 13,28 ft lb
EN