Dynamic Range; Auto Power Down - Yamaha T-D500 Bedienungsanleitung

2
Press B / C to select the desired station
order setting and then press ENTER.
Choice
Alphanumeric
Default setting. Stations are listed in the
alphanumeric order.
Active
This unit lists the currently active DAB
stations first, and then other DAB
stations in the alphanumeric order.
Ensemble
Select this setting to browse through the
registered DAB stations from the lowest
to the highest channel labels (see page
10).
y
While pressing B / C to select the desired setting, "*" is
displayed next to the current setting.
■ Tune Aid
Measure reception strength of the received signal (from 0
(none) to 100 (best)).
1
Select "Tune Aid" in the DAB function menu.
2
Press B / C to select the desired DAB
channel.
The strength of the selected DAB channel signal is
displayed on the front panel display. Adjust the
orientation of the DAB antenna so that the strength of
the selected DAB channel signal gets stronger.

■ Dynamic Range

You can change the dynamic range compression setting.
This is especially useful when you listen to a DAB station
in a noisy environment or at a low volume at night.
1
Select "Dynamic Range" in the DAB function
menu.
2
Press B / C to select the desired dynamic
range compression setting and then press E
or ENTER.
Choice
AUTO
Default setting. This unit utilizes the
dynamic range compression
automatically if it is transmitted.
OFF
This unit does not utilize the dynamic
range compression.
y
While pressing B / C to select the desired setting, "*" is
displayed next to the current setting.
Description
Description
■ DAB Clear
Clears all DAB station information and preset settings
stored in the unit.
y
You can also perform DAB Clear by pressing and holding
CLEAR for more than 3 seconds in the preset tuning mode. See
"Clearing the preset DAB station" on page 8.
Note
Once DAB Clear is performed, the deleted information and preset
settings cannot be restored.
1
Select "DAB Clear" in the DAB function
menu.
2
Press B / C to select "OK" and then press E
or ENTER.
After DAB Clear is complete, the Autoscan Full
function starts automatically (see page 6).
y
To cancel the operation, select "CANCEL".

■ Auto Power Down

This unit automatically enters standby mode if it is not
operated for specified amount of time.
This setting is effective for all tuning modes.
1
Select "Auto Power Down" in the DAB
function menu.
2
Press B / C to select the desired auto power
down setting and then press E or ENTER.
Choice
OFF
This unit will not be set to standby
mode automatically.
4 Hours,
This unit is set to standby mode
automatically after the specified
8 Hours,
amount of time passes.
12 Hours
Default setting is "8 Hours".
y
While pressing B / C to select the desired setting, "*" is
displayed next to the current setting.
DAB TUNING
Description
9
En