Fm/Am Tuning; Automatic And Manual Tuning - Yamaha T-D500 Bedienungsanleitung

Automatic and manual tuning

FM MODE
FM MODE
BAND
■ Automatic tuning
Automatic tuning is effective when station signals are
strong and there is no interference.
1
Press BAND repeatedly to select FM or AM
as the reception band.
2
Press and hold TUNING H / I for more than
2 seconds to begin automatic tuning.
When this unit is tuned into a station, the TUNED
indicator lights up and the frequency of the station is
displayed on the front panel display.
y
• On the front panel, press TUNING MODE repeatedly to
select "Auto tune" and then rotate PRESET/TUNING.
• If the station provides Radio Data System information, the
program service information will be displayed on the front
panel display (see page 13).

FM/AM TUNING

■ Manual tuning
If the signal from the station you want to select is weak,
tune into it manually.
1
TUNING 2
MODE
BAND
PRESET/
TUNING
TUNING H / I
■ Improving FM reception
If the signal from the station is weak and the sound quality
is not good, set the FM radio wave reception mode to the
monaural tuning mode to improve reception.
Press FM MODE repeatedly to select "AUTO
STEREO" (stereo mode) or "MONO" (monaural
mode) when this unit is tuned into an FM radio
station.
• When this unit is in the stereo tuning mode, the
• When this unit is in the monaural tuning mode, the
Note
Even if this unit is in the stereo tuning mode, the STEREO
indicator does not light up when the current program is monaural.
Press BAND repeatedly to select FM or AM
as the reception band.
Press TUNING H / I to select the desired
frequency.
When this unit is tuned into a station, the TUNED
indicator lights up.
y
On the front panel, press TUNING MODE repeatedly to
select "Manual tune" and then rotate PRESET/TUNING.
STEREO indicator lights up on the front panel display.
STEREO indicator goes off.
11
En