AEG FAVORIT 54030VI0 Benutzerhandbuch Seite 27

7.1 Using the detergent
D A B
30
20
A B D
3
0
2 0
7.2 Setting and starting a
programme
Setting mode
The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation, all the programme
indicators come on.
If the control panel shows other condi-
tions, press and hold function buttons
(B) and (C) at the same time until the ap-
pliance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Press the button of the programme
you want to set.
• The related programme indicator
stays on.
1.
2.
3.
4.
C
5.
A
+ -
C
Press the release button (B) to open
the lid (C).
Put the detergent in the compart-
ment (A) .
If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
If you use detergent tablets, put the
tablet in the compartment (A).
Close the lid. Make sure that the re-
lease button locks into position.
• All the other programme indicators
go off.
4. Close the appliance door. The pro-
gramme starts.
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button again and
again until the indicator of the num-
ber of hours you want to set comes
on. You can set 3, 6 or 9 hours.
• The delay indicator comes on.
3. Close the appliance door. The count-
down starts. When the countdown is
completed, the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
ENGLISH
27