Yamaha PSR-4000 Bedienungsanleitung Seite 154

Seite von 165

/ 165
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

MIDI Implementation Chart • Implementierungstabelle • Table d'implémentation • Gráfico de implementación

*1 The RIGHT1, RIGHT2, LEAD, LEFT, HARMONY, MULTI PAD,

and ACCOMPANIMENT parts can be independently transmitted

via the panel controls.

*2 The tone generator normally functions as a 16-channel multi-timbre

tone generator in response to MIDI input. MIDI messages therefore

do not normally affect the panel voices or other panel settings. The

MIDI messages listed below, however, do affect the panel voice,

style, multi pad, and song settings:

• MIDI master tuning, MIDI master volume, MASTER TRANS-

POSE.

• Drum setup-related exclusive messages.

• System exclusive messages which change the reverb, chorus,

or DSP effect settings.

The KEYBOARD mode can be selected via panel control. Note on/

off messages received on KEYBOARD MODE channels are han-

dled in the same way as note on/off data from the internal key-

board.

Only the following channel messages are recognized in this mode:

• Key on/key off.

• Control change: bank select (RIGHT1 only), modulation, main

volume, (RIGHT1 only), expression, sustain.

• Program change (RIGHT1 only).

• Pitch bend, all notes off.

*3 Limited to the range 21...108 on KEYBOARD MODE channels.

*4 BANK SELECT MSB

MSB 00H LSB 00H

MSB 00H LSB 70H~7FH Non-GM preset panel voices.

MSB 6FH LSB 60H~7FH Custom voice orchestra voices.

MSB 7FH LSB 00H

MSB 7FH LSB 6FH

Channel 10 is reserved for drum kit voices after a GM ON mes-

sage is received.

No voice change occurs when only a bank change message is

received. The latest bank change message is applied when a

program change message is received.

*5 These Control Change messages are not transmitted by the PSR-

4000 panel operation, but may be transmitted by the accompani-

ment style playing.

150

Preset GM tone generator.

Preset drum kit voices.

Custom voice drum kit voices.

*6 NRPN transmission/reception

The following parameters are supported.

NRPN

Data entry

MSB LSB

Parameter Name/Range

01H 08H

mmH - -

Vibrato Rate

mm : 00H - 40H - 7FH (-64 - 0 - +63)

01H 09H

mmH - -

Vibrato Depth

mm : 00H - 40H - 7FH (-64 - 0 - +63)

01H 0AH

mmH - -

Vibrato Delay

mm : 00H - 40H - 7FH (-64 - 0 - +63)

01H 20H

mmH - -

Filter Cutoff Freq.

mm : 00H - 40H - 7FH (-64 - 0 - +63)

01H 21H

mmH - -

Filter Resonance

mm : 00H - 40H - 7FH (-64 - 0 - +63)

01H 63H

mmH - -

EG Attack Time

mm : 00H - 40H - 7FH (-64 - 0 - +63)

01H 64H

mmH - -

EG Decay Time

mm : 00H - 40H - 7FH (-64 - 0 - +63)

01H 66H

mmH - -

EG Release Time

mm: 00H - 40H - 7FH (-64 - 0 - +63)

14H rrH

mmH - -

Drum Filter Cutoff Freq.