Yamaha PSR-4000 Bedienungsanleitung Seite 148

The DSP Effects & Parameters • DSP-Effekte und -Parameter • Effets et paramètres DSP •
17. Chorus 1 18. Chorus 2
22. Flanger1 23. Flanger2
The chorus effects combine delay and modulation to effectively thicken and add warmth to the sound.
Flanging is a fairly pronounced effect based primarily on delay time modulation. By adjusting the vari-
ous parameters you should be able to create an extremely broad range of sounds, from gentle shimmering
to wild sweeps.
1. LFO FREQUENCY Range: 0 ... 127
Sets the speed of LFO (Low Frequency Oscillator) modulation, and therefore the rate of effect variation.
2. LFO PM DEPTH
Sets the depth of phase modulation. Higher values produce deeper modulation and therefore a more pro-
nounced effect.
3. FEEDBACK LEVELRange: –63 ... 0 ... +63
Determines the amount of effect-sound feedback returned to the input of the effect stage. Higher negative or
positive values produce a more pronounced effect.
4. DELAY OFFSET
Varies the flanger delay time (the flanger effect is basically produced by modulating the delay time of one
signal in relation to another). Shorter delay times produce the greatest effect in the high-frequency range,
while longer delay times extend the effect to the middle and lower frequencies.
26. Symphon.
Symphonic is a broad, sweeping effect that adds a sense of scale to the sound.
1. LFO FREQUENCY Range: 0 ... 127
Sets the speed of LFO (Low Frequency Oscillator) modulation, and therefore the rate of effect variation.
2. LFO DEPTH
Sets the depth of modulation. Higher values produce deeper modulation and therefore a more pronounced
effect.
3. DELAY OFFSET
Varies the symphonic effect delay time (the Symphonic effect is basically produced by modulating the delay
time of one signal in relation to another). Shorter delay times produce the greatest effect in the high-frequency
range, while longer delay times extend the effect to the middle and lower frequencies.
27. Phaser
A traditional "phaser" effect, producing a gentle phase-shift sound that can be used to add extra animation to
your sound.
1. LFO FREQUENCY Range: 0 ... 127
Sets the speed of LFO (Low Frequency Oscillator) modulation, and therefore the rate of effect variation.
2. LFO DEPTH
Sets the depth of modulation. Higher values produce deeper modulation and therefore a more pronounced effect.
3. PHASE SHIFT
Sets the phase difference between the left and right channel phaser signals. The larger the value, the greater the
"spread" in the sound. A setting of "0" produces a centered effect.
4. FEEDBACK LEVEL Range: –63 ... 0 ... +63
Determines the amount of effect-sound feedback returned to the input of the effect stage. Higher negative or posi-
tive values produce a more pronounced effect.
144
19. Chorus 3
24. Flanger3
Range: 0 ... 127
Range: 0 ... 63
Range: 0 ... 127
Range: 0 ... 63
Range: 0 ... 127
Range: 0 ... 127
20. Chorus 4 21. Chorus 5
25. Flanger4