GOAL ZERO yeti 400 Lithium Benutzerhandbuch Seite 9

1. INPUT shows the amount of power (watts) going into the Goal Zero Yeti while
charging. If charging from solar, you'll see the watts change as you reposition the panels
into/out of the sunlight.
a. LO will be displayed if power flow is below a measurable amount.
2. OUTPUT shows the amount of power (watts) your devices are using while plugged
into the Goal Zero Yeti.
3. TIME TO EMPTY/FULL shows the amount of time before your Goal Zero Yeti is
completely charged or empty, depending on if the net amount of power going into the
Goal Zero Yeti is positive or negative.
4. BATTERY LEVEL shows 5 segments, approximating 20% - 40% - 60% - 80%
-100% capacity. As you use your Goal Zero Yeti, segments will disappear from the
display, indicating the remaining charge. When charging your Goal Zero Yeti you will notice
a battery segment blinking. This indicates the current charge status. Once your Goal Zero
Yeti is fully charged, all battery segments will be lit and remain solid. As long as there is
more power going into the Goal Zero Yeti than is being pulled from the output ports, the
display will also indicate an estimated time until fully charged. This is an estimated time
based on the power input and output numbers at that time; it will adjust to a shorter or
longer time if the charge or discharge rates fluctuate. Note that when you first plug in a
power source, whether it's a solar panel or a wall charger, the Yeti may take a minute to
detect and adjust its charge circuitry before is starts drawing power from the source.
Pressing the UNIT button will scroll through different output and power consumption
settings.
Pressing and holding the UNIT button will reset the WATT HOUR output counter.
Pressing the INFO button will alternate the screen between showing the detailed battery
state of charge percentage and the Time to Empty/Full.
7