Environmental Protection; Additional Safety Warnings - Ryobi R18CS Anleitung

Lower guard may be retracted manually only for
special cuts such as "plunge cuts" and "compound
cuts". Raise lower guard by retracting handle, and
as soon as blade enters the material, the lower guard
must be released. For all other sawing, the lower guard
should operate automatically.
Always observe that the lower guard is covering the
blade before placing saw down on bench or floor.
An unprotected, coasting blade will cause the saw to
walk backwards, cutting whatever is in its path. Be
aware of the time it takes for the blade to stop after
switch is released.

ADDITIONAL SAFETY WARNINGS

The dust produced when using the product may be
harmful to your health, inflammable, or explosive.
Do not inhale the dust. Use a dust extraction system,
and wear a suitable dust protection mask. Remove
deposited dust thoroughly, e.g., with a brush and
vacuum cleaner.
Do not use any abrasive wheels.
Use only blades specified in this manual, complying
with EN 847-1.
Avoid overheating the blade tips. Do not use dull or
damaged blades. Do not force the tool.
Do not use blades of larger or smaller diameter than
recommended.
Wear ear protection.
Clamp workpiece with
damage.
Thoroughly check the material to be cut, particularly
when using recycled wood, for foreign objects such
as nails, screws, and staples. If nails, screws, staples
or similar items contact the blade whilst cutting, the saw
others may occur.
Do not touch the saw blade immediately after
sawing. The saw blade gets hot during sawing.
MAINTENANCE
When servicing, use only original manufacturer's
replacement parts. Use of any other parts may create a
hazard or cause product damage.
Clean the tool and guarding system with clean cloths, or
blow it clean with compressed air.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, dust, oil, grease,
etc.
Do not attempt to modify this tool or create accessories
not recommended for use with this tool.
All repairs should be performed by an authorised Ryobi
service centre.
2
a clamping device.

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing
of as waste. The machine, accessories
and packaging should be sorted for
environmental-friendly recycling.
SYMBOLS
Safety alert
No-load speed
Blade diameter
CE conformity
EurAsian Conformity Mark
Please read the instructions carefully
before starting the machine.
Do not cut metals
Wood
Width of cut
Blade teeth
Wear eye protection
DANGER: Sharp blade
Do not expose to rain
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authority or retailer for recycling
advice.
English