Troubleshooting - Avanit SXHD Bedienungsanleitung

Troubleshooting

10 Troubleshooting
This section includes a list of general errors that could occur with operation of the
receiver. Each error states a possible cause and solutions.
Symptom
The display does not
light.
No audio or video;
the receiver states
"OFF" and the red LED
lights up.
No audio or video.
The TV set does not
show a picture.
Picture only in black
and white and/or
incorrect synchroni-
zation.
The remote control
does not operate.
Display flashes
New operating software for the receiver will be published, if required. This can be
easily downloaded at the website www.avanit.tv.
130
Possible cause(s)
The power cord is not con-
nected.
The power switch is not
switched on.
The receiver is in standby
mode.
No signal or only weak signal. Check the cable connections to the
The system is not correctly
connected.
The video format of your
receiver is not correctly set.
The batteries are empty.
The remote control shows
into wrong direction.
Short circuit at antenna in.
Solution
Connect the power cord to the power
outlet.
Switch on the power switch.
Press the POWER key to switch on the
receiver.
receiver and from the receiver to the
connected devices; fasten cables, if
required.
Verify connection of cable and fasten
cable, if required.
Adapt broadcast television system of
the receiver to the broadcast television
system of the TV set.
Replace empty batteries with new
batteries.
Direct the remote control towards the
front panel of the receiver.
Pull off antenna plug from LNB in and
check the same.
Verify that your antenna installation is
properly installed.
AVANIT SXHD