Installation - Avanit SXHD Bedienungsanleitung

7.3 Installation

If the receiver is connected to a uni-
cable system, then RAPS installation will
automatically cancel. The window to
the right will open.
1. Press the red function key (SHIFT)
to open the submenu Antenna
Setup.
2. Select the menu item LNB Freq to
set Unicable(9750-10600).
3. Press the green function key to
open the window Antenna Setup
Unicable Setting.
7. Select the menu item IF Channel
and set the IF channels (start with
channel 1; respectively allocate one
of the IF channels - in ascending or-
der - to the connected receivers).
8. Select the menu item Center Freq to set the frequency corresponding to the IF
channel (see allocation table).
9. Select the menu item Sat Position to set the respective satellite position.
10. Mark the button Save and press OK to save your entries and to return to the first
window Antenna Setup
or
mark the button Cancel and press OK to discard any previous entries in this win-
dow and to return to the first window Antenna Setup without saving.
11. Press the red function key to open
the window Antenna Setup Center
Freq.
12. Leave the menu by pressing EXIT
(settings will be saved).
RAPS installation will be continued
automatically.
AVANIT SXHD
Operation in a Unicable System
127