Jacobsen Groom Master II Handbuch Seite 13

4.6 PARKING / SERVICE BRAKE ________________________________________________
Inspect brakes pads:
whenever wheels are removed,
if groomer creeps on hills with parking brake applied,
or there is a no ticeable increase in stop ping distance.
To adjust brake cables:
1. Raise groomer and support the unit using jack sta nds or
blocks so that all th ree wheels are slightly raised off the
ground.
2. Back off nu t (G).
3. With the brake pedal all the way up (disengaged) turn in
adjusting nut (H) and spin wheels slowly by hand until
you feel brakes engage and wheels begin to bind.
4. Back off adjuster nut (H) slightly until wheels again turn
freely.
5. Tighten nut (G) to lock adjustment in pla ce.
6. Repeat for second cable.
Before returning unit to operation, drive groomer in a flat,
open area and check operation of brakes to make sure they
are operating correctly. Check parking brake to make sure it
engages properly and prev ents the groomer from rolling
downhill.
G
H
ADJUSTMENTS
Figure 4E
en-13
4