Sharp XV-Z9000U/E Service Anleitung Seite 27

No. Adjusting point
17 White balance
checking and
readjustment
18 Color-related
performance
checking
19 Video-related
performance
checking
20 RGB-related
performance
checking
21 Off-timer per-
formance
22 Thermistor
performance
checking
23 Auto sync
performance
checking
24 Delivery set-
tings
Adjusting conditions
1. Take the adjustment con-
ditions discussed for Item
11.
1. Feed the color bar signal.
1. Feed the monoscope pat-
tern signal.
1. Feed the RGB signal.
1. Heat the thermistor with a
hair dryer.
1. Feed the phase check pat-
tern signal.
Adjusting procedure
Make sure there is no white balance difference be-
tween the set and the standard monitor.
1. Select L1 from the process mode LINE.
Check the Color and Tint performance.
1. Select L2 from the process mode LINE.
Check the Picture, Brightness and Sharpness per-
formance.
1. Select L4 from the process mode LINE.
Check the Picture, Brightness, Red, Blue, Clock,
Phase, H-Position and V-Position performance.
1. Select OFF from the process mode LINE.
Make sure the off-timer starts with 5 minutes
onscreen and the set turns itself off in 5 minutes.
1. Make sure that the temperature is indicated.
1. In the VGA, SVG Aand XGAmodes, make sure the
Clock, Phase, H-Pos and V-Pos settings can be au-
tomatically adjusted.
1. Make the following settings.
Destination Adjustment process Remote control setting
XV-Z9000U
XV-Z9000E
27
XV-Z9000U/E
S4 Factory setting 4
S3 Factory setting 3