Important Information For Installing Your Carradio - AEG AR 4026 DVD Bedienungsanleitung

English
26
• The cross-section of the plus and minus cable must not
exceed 1.5 mm².
Installation Tips:
• Cable protection sleeves protect cables against fraying
on sharp body parts.
• The insulation of the cables must not be damaged dur-
ing installation.
• It is essential to use the correct tools when installing car
hi-fi.
Depending on the model, your vehicle may deviate from the
above description. We do not accept any liability for damage
caused by installation or connection errors or for consequen-
tial damage.
Important Information for installing your
carradio!
1. The device is designed for the minus pole of the battery,
which must be connected to the body of the vehicle.
Please check this before installation.
2. When installing/connecting your device please note that
not every vehicle is equipped with an "ISO connection".
In this case we recommend the use of an ISO adapter
specifically designed for your vehicle.
Adapters are available from car accessory shops and/or
from your vehicle workshop.
3. Depending on the specific car type, different wiring
connection of the "Duration +" wire (Constant current
connection) are available. (However, this is necessary for
storing the radio stations.)
In order to guarantee all functions, installation in line with
these instructions is essential. In cases of doubt please
contact an authorised car workshop.
Due to the various types of motor vehicles and motor
manufacturers, it is not possible to guarantee that the
pin assignment of the ISO plug is correct, even if the ISO
plug connections fit together mechanically. It may there-
fore be necessary to modify the electrical connection or
use vehicle-specific adapters.

NOTE:
If the device is correctly connected, the radio can
be switched on and off via the ignition. If the stored
stations are lost, this indicates that the radio is not
receiving any "continuous +", current which is required
for storing the ations.
CAUTION:
Where there is a connection to "continuous +" without
the ignition being switched on, the car battery might be
drained of power even if the radio is switched off. This
may even result in the battery becoming completely flat.
05_AR4026DVD_AEG_SK.indd 26
4. The angle of inclination when a car radio is installed
must not exceed 20°, as in the case of greater angles of
inclination the function of the car radio (CD Player) can no
longer be guaranteed.
5. Depending on the specific car type, interferences can be
possibly arise during radio/CD/DVD operation. These
interferences can avoided easily with an additional Inter-
ferences filter. Your car radio is originally prepared with
an Interference Filter already.
In these case, please contact your authorized car dealer.
6. When installing your radio please ensure that there is
enough space at the rear of the radio to ensure sufficient
cooling.
7. For the antenna connection there are two different
norms. The first of these is the old (50 ohm) version with
a long protruding round contact on the vehicle and a
round socket on the radio end. The second is the ISO-
standardised antenna plug (150 ohm). Adapters for both
formats are available from accessory manufacturers and/
or your car workshop.

NOTE:
Important information for VW/Audi vehicles: The antenna
in your vehicle may be an active antenna. This requires a
power supply which is only provided by the original car ra-
dio. If this is the case, use an antenna adapter for phantom
power supply.
Antenna adapters can be found in car accessory outlets
and/or at your car repair shop.
03.08.11 12:32