Handling A Cd/Dvd - AEG AR 4026 DVD Bedienungsanleitung

English
40
Fault Symptoms Cause
The CD does not The volume con-
play back after trol is set too low.
being inserted
The device has
into the device.
not been correctly
connected.
CD works intermit- The surface of the
tently (dropouts). road is uneven.
The device is not
firmly installed.
The CD is dama-
ged.
The CD is dirty.
The device
may have been
installed in the
vehicle at the
wrong angle.
No function. The ignition is
switched off.
Device cannot be Incorrect con-
switched on or off nection (each
via the ignition. car manufacturer
wires the ISO
connection in the
vehicle differently).
The device does The microcom-
not work correctly puter has been
(EJECT, LOAD, interfered with by
PLAY). electromagnetic
fields.
The device cannot The control
be operated, but processor of the
"hangs up". device may have
been blocked by
overvoltage or un-
dervoltage in the
vehicle electrical
system.
05_AR4026DVD_AEG_SK.indd 40
Solution Fault Symptoms
Turn up the No radio recep-
volume. tion.
Check the +12 V
and earth connec-
tion.
Poor radio recep-
Wait until the
tion.
road becomes
smoother before
playing the CD.
Install the device
firmly. Ensure that
the rear attach-
ment is used if the
vehicle does not
have any suitable
In automatic
retainer for the
search mode the
rear section of the
radio does not
device.
stop at a transmit-
Try another CD.
ting station.
If this works
DVD cannot be
correctly, the first
played.
CD is probably
damaged. Audio or Video
interference from
Clean the CD.
video files which
Please note that
are played back
a maximum
via USB or memo-
inclination of 20°
ry card.
degrees should
not be exceeded!
Turn the ignition

Handling a CD/DVD

key to "ON" or
"ACC".
Cleaning the CD
Replace the fuse
by another 15 A
fuse.
Please contact
your car workshop
or a vehicle
CAUTION:
specialist for con-
do not use any solvents such as petrol or thinning agents.
nection adapters
commercially available cleaning substances or antistatic
may specifically for
sprays will damage the device.
your model.
Remove the CD
Inserting the CD
and insert it again.
Switch the device
off and on again.
Press the RESET
button.
CAUTION:
if there is already a cd in the cd slit, do not try to insert a
second cd. this may damage the device.
Cause Solution
The antenna cable Insert the antenna
is not connected. cable firmly into
the antenna
socket of the
device.
It is possible that Please contact
your vehicle has your car workshop
a special antenna or a vehicle spe-
(phantom-po- cialist. (For other
wered antenna.) manufacturers
there are specific
phantom power
supply adapters
and voltage adap-
ters available.)
The transmission Tune in to a radio
signals are too station manually.
weak.
DVD not finalised. Use a finalised
DVD.
Data flow is Pause play using
the II button.
"sluggish". (See
section "Opera- Wait a few se-
ting Instructions" conds and re-start
on page 7 for a playback.
detailed explana-
tion).
Before playing a CD, wipe it off
with a clean, dust-free cleaning
cloth. Pull out the CD in the
direction of the arrow.
If the CD is inserted with the
printed side facing downwards,
the device may be damaged.
Always insert the CD with the
label facing upwards.
03.08.11 12:32