Technical Data - automix 10 Betriebsanleitung

SENSOR RESISTANCE
Sensor resistance is measured at the two middle wires of the 4-wire cable contact.
1800
1600
1400
1200
1000
800
60
0 20 40
Supply water sensor T1
OPTIONALS
AUTOMIX 10RB is a room sensor for measuring and
setting the temperature inside the house.
AUTOMIX 10RB should be installed if the room tem-
perature fluctuates because the building is affected
by sunlight or wind.
A green LED indicates that power is on. When the
motor runs, the LED dims slightly.

TECHNICAL DATA

Type of control
Voltage
Adapter
Power consumption
Torque
Angle of rotation
Heating graphs
Parallel displacement
Min. supply water limiter
Max.supply water limiter
Room sensor AM 10RB
Remote control AM 10RC
Manual operation
Ptotection class
Dimensions
Weight
80 100⁰C
PI-control with microprocessor
18 VAC 50/60 Hz
230/18 VAC 200 mA with 1,7 m wire
3 VA
5 Nm
90°
1 to 9, stepless
+/- 10°C supply water temperature, stepless
+15°C to +35°C supply water temperature
+40°C to 90°C supply water temperature
+12°C to 27°C room temperature, stepless
-9°C to +6°C supply water temperature, stepless
Yes, in case of power failure
IP 40
80 x 90 x 93 mm
0,53 kg
50
40
30
20
10
-30 -20 -10
0 +10
Outdoor sensor T2
AUTOMIX10RC is a remote control designed for
floor heating systems. It is used to conveniently
adjust/parallel displace the heating graph. Sup-
ply water temperaure can be lowered 9 °C or
raised 6 °C. AUTOMIX 10RC corresponds to the
function parallel displacement F.
A green LED indicates that power is on. When the
motor runs, the LED dims slightly.
1
+20⁰C
english