automix 10 Betriebsanleitung Seite 14

english
VALVE MOTOR AUTOMIX 10
1. Turn the spindle of valve A counter clockwise
to the end position (open or closed). Remove
the knob/handle without changing the position
of the spindle.
2. Screw the anti-rotation stop B into a convenient
hole on the valve (if necessary remove an
existing screw).
3. Slide linkage C over the valve spindle. Place
motor D onto linkage C until the anti-rotation
stop B engages into the slot of the motor.
4. On delivery the motor is in the anti-clockwise
position. Turn scale E according to the open/
closed direction of the valve.
5. Place handle F onto the motor ensuring that the
arrow points to the left end position of the scale.
Tighten the whole unit by means of screw G.
6. Using a screwdriver (No.3) turn the disengaging
button H from "A" to "HAND" position and rotate
the valve with handle F from one end position
to the other. It is important that the motor can
be moved from one end stop to the other (90°).
7. Turn disengaging button H back to "A" which is
the AUTOMATIC position.
FRONT PANEL OF MOTOR
A. Red LED – valve opens
B. Green LED – valve closes
C. A = Automatic position,
HAND = Manual position
D. Graph setting
E. Right or Left turning direction of motor
F. Parallel displacement of graph
G. Handle/Indicator of valve position
H. Min. and Max. supply water temperature
1