Klauke EBS 12 Bedienungsanleitung Seite 27

Instruction Manual EBS 12
_______________________________________________________________________________________________________________________
5.3. Service and maintenance instruction
The reliable performance of the tool is dependent on careful treatment and service. This
presents an important condition to ensure a proper function. To safeguard this, the tool has to
be maintained and serviced regularly.
We would like to draw your attention to the following points:
1. The electric-hydraulic cutting unit has to be cleaned and dried after each use before being
put into the transportation case.
2. In order to guarantee a proper function of the machine the cutting tool should be serviced
annually or after 10.000 cycles by one of our Authorized Service Centers (ASC's).
3. The battery and charging unit must be protected against humidity and foreign objects.
4. The bolt joins, the piston and the guides must be oiled regularly in small amounts.
In order to avoid possible malfunctions we recommend a manufacturer service consisting of
disassembly, cleaning, exchange of possibly worn out parts, assembly and final check.
Within the determined use of the tool only the battery, the blades (Pos. 4+7) are permitted to be
changed by the customers.
Attention
Do not damage the seals of the tool.
If the seals are damaged the warranty is invalidated.
Instruction manual EBS 12
______________________________________________________________________________________________________________________
5.3. Service and maintenance instruction
The reliable performance of the tool is dependent on careful treatment and service. This
presents an important condition to ensure a proper function. To safeguard this, the tool has to
be maintained and serviced regularly.
We would like to draw your attention to the following points:
2. The electric-hydraulic cutting unit has to be cleaned and dried after each use before being
put into the transportation case.
2. In order to guarantee a proper function of the machine the cutting tool should be serviced
annually or after 10.000 cycles by one of our Authorized Service Centers (ASC's).
3. The battery and charging unit must be protected against humidity and foreign objects.
4. The bolt joins, the piston and the guides must be oiled regularly in small amounts.
In order to avoid possible malfunctions we recommend a manufacturer service consisting of
disassembly, cleaning, exchange of possibly worn out parts, assembly and final check.
Within the determined use of the tool only the battery, the blades (Pos. 4+7) are permitted to be
changed by the customers.
Attention
Do not damage the seals of the tool.
If the seals are damaged the warranty is invalidated.
page 27
page 27