Klauke EBS 12 Bedienungsanleitung Seite 24

Instruction Manual EBS 12
_______________________________________________________________________________________________________________________
5. Remarks in respect of the determined use
Before cutting ACSR steel cores it must be safeguarded that the line is not live since this is not
an insulated tool. Is this not possible special precaution measures acc. to EN 50110-1 for
working near live parts must be provided.
5.1. Operation of the tool
First you have to check whether the piston is fully retracted. If necessary pull the retract slide
(Pos. 2, picture 2 Pos. B) in the direction of the arrow.
After positioning the wire/bolt into the open cutting blades (see Picture 3) the cutting cycle is
started by actuating the trigger (Pos. 1, picture 2 Pos. A). The cutting cycle is characterized by
the closing motion of the blades. The moveable blade (Pos. 7) approaches the stationary blade
(Pos. 4) in a linear movement.
Attention
The cutting process can be interrupted at any moment by releasing the trigger.
By actuating the retract slide (Pos. 2, picture 2 Pos. B) the piston, respectively the moveable
blade returns into the starting position.
After reaching the max. operating pressure the piston, respectively the moveable blade (Pos. 7),
returns into their starting position automatically. In order to save battery capacity we
recommend to manually retract the piston after the wire/bolt is cut.
Instruction manual EBS 12
_______________________________________________________________________________________________________________________
5. Remarks in respect of the determined use
Before cutting ACSR steel cores it must be safeguarded that the line is not live since this is not
an insulated tool. Is this not possible special precaution measures acc. to EN 50110-1 for
working near live parts must be provided.
5.1. Operation of the tool
First you have to check whether the piston is fully retracted. If necessary pull the retract slide
(Pos. 2, picture 2 Pos. B) in the direction of the arrow.
After positioning the wire/bolt into the open cutting blades (see Picture 3) the cutting cycle is
started by actuating the trigger (Pos. 1, picture 2 Pos. A). The cutting cycle is characterized by
the closing motion of the blades. The moveable blade (Pos. 7) approaches the stationary blade
(Pos. 4) in a linear movement.
Attention
The cutting process can be interrupted at any moment by releasing the trigger.
By actuating the retract slide (Pos. 2, picture 2 Pos. B) the piston, respectively the moveable
blade returns into the starting position.
After reaching the max. operating pressure the piston, respectively the moveable blade (Pos. 7),
returns into their starting position automatically. In order to save battery capacity we
recommend to manually retract the piston after the wire/bolt is cut.
page 24
page 24