Assembly And Operation - Clearaudio Champion Bedienungsanleitung

3. Assembly and Operation

First please put on the white gloves to avoid finger prints on the surface of the acrylic chassis during
installation.
12. Place the chassis upside down on a clean and
soft surface. Now screw the winding bolts into
the three pre-threaded holes. Afterwards
mount the acrylic spikes.
13. Tear the upper and lower part of the platter
bearing apart. Caution: pay attention not to
place any of the grease on the acrylic surface
of the chassis. Mount the lower part with the
washer and screw into the chassis. The screw
should be tightened with a wrench.
14. Squeeze a little bit (1 or 2 drops) of the
bearing oil into the upper part of the platter
bearing.
Seite/Page 15
Champion
© clearaudio electronic GmbH 2007
Bedienungsanleitung
USER MANUAL