elv ALC 7000 Expert Bedienungsanleitung Seite 28

the corresponding display indicator.
However, if the user wants to program another channel with a battery connected,
press the „Kanal" (channel) key repeatedly until the relevant channel number
appears in the display.
- In order to enter the battery data, press the „Eingabe" (input) key briefly.
- The currently activated battery technology appears in the display (NC/NiMH
or Lead), whereby manual adjustment is possible using the arrow keys „↑"
and „↓").
- The data is applied after pressing the „Eingabe" (input) key briefly.
- Press the „Input" key briefly again to switch the unit to input mode for the
nominal battery capacity. The display then only shows the last nominal
capacity programmed for the channel together with the „Functions" symbol.
The nominal battery capacity range can be adjusted between 0.01 Ah and
99.99 Ah.
- The set value can be changed as follows using the Cursor keys:
- The lowest value digit on the right of the nominal capacity display flashes. Use
the arrow keys „(„↑" and „↓") to change the digit value to that required.
- Then press the „←" key to move to the next digit (2nd from the right) which then
flashes.
- After changing the digit to the value required, press the „↓" and „↑" keys to
move to the next digits until the nominal capacity setting is completed.
- In order to correct the capacity setting just completed, press the „←" key as
often as necessary until the relevant digit flashes and then use the „↓" and „↑"
keys to set the required digit value.
- Conclude setting the nominal capacity by pressing the Input key briefly.
- Press the „Eingabe" (input) key again to switch the program to the next menu
option, which concerns setting the nominal battery voltage. In most cases, no
adjustments need to be made to this option because the processor automa-
tically determines the voltage value according to the voltage measured on the
battery connected. Corrections only need to be made when the processor
cannot determine the value properly as a result of too extreme voltage
deviations, e.g. in the cases where the battery charge which is too low.
- Use the Cursor keys, "↓" and "↑", to adjust the voltage setting in steps of 1.2 V
for NC/NiMH batteries and steps of 2 V for lead batteries.
- Press the Input key briefly to set the nominal battery voltage value and the unit
then switches to the operating mode to set the charge/discharge current.
6.2. Setting the charge/discharge current
- Programming the charge/discharge current is performed analog to setting the
nominal capacity, using the Cursor keys.
- The setting procedure starts with the charge current. „Stromvorgabe" (set
28