Data Input - elv ALC 7000 Expert Bedienungsanleitung

5. Starting Up, Basic Setting
Check the batteries for signs of rust and other oxidation damage, leaks
and general damage before connecting them to the charging unit . Do not
charge batteries with such defects; dispose of them according to the
disposal label.
5.1. Starting up
Only put the unit into operation when no batteries are connected (except following
a power failure or short transport, refer to Chapter "Backup function"). Never
leave batteries connected to the unit for a longer period (e.g. several days) when
it is switched off. These could be discharged in an uncontrolled way or, after a
longer period, leak and damage items nearby.
- Set the unit down on an even, horizontal, flat surface with sufficient space for
air to circulate under and around it.
- Plug the power plug into a 230 V mains power outlet.
- Switch on the mains switch.
- The unit then performs a self-test during which all the available segments on
the LC display are displayed to control its functionality (see figure below).
After showing display briefly, the unit switches the display to the normal
operating mode.
5.2. Basic setting
- At this point, the unit is in standby mode, ready to use. The last unit
configuration used and stored or, following the first initialization, the standard
configuration programmed at the factory appears in the display.

6. Data Input

6.1. Entering the battery data
Each unit charge output is individually monitored and, as a result, each battery/
battery pack is treated individually. This means it is possible to connect batteries
implementing different technologies to the unit simultaneously (e.g. a 12 V lead
gel battery connected to channel 1, a NiMH battery to channel 3 and an NC
battery to channel 4).
As soon as a battery is connected to a pair of output sockets of a charging
channel, the microprocessor detects it and activates the channel together with
Kanal Spannung
Au ffrischen
Tief- Entladen
Defekt
Strom vorgabe
Au to
Voll
T
E
S
Kapazität
T
R A M
Temp. NC/NiMH
27
V
mA Initialization self-test
mAh