Grundig LENARO 92 MFW 92-6110/9 DVD Service Anleitung Seite 26

Allgemeiner Teil / General Section
20
1 - 26
SETTINGS
____________________________________________________________________________________
Rear
»Off«
Subwoofer
»internal«
Note:
When using a passive subwoofer, you must place the jumper next to the ter-
minal socket in the »E« position.
6
Select the »Level« line with
– This setting becomes necessary when active loudspeakers or an external
amplifier are connected to the cinch sockets.
Note:
The following options are available:
»Variable« – Select this setting when active loudspeakers or individual
amplifiers are connected to the cinch sockets. The volume is
adjusted with the remote control of the television set.
»Solid« – Select this setting when a full amplifier (e.g. Dolby Digital
amplifier with 5.1 inputs) is connected to the cinch sockets.
The volume is adjusted on the amplifier.
7
Select the »Type« line with
– This sets the loudspeaker size to the appropriate frequency range. Depen-
ding on the selected setting, the television distributes the frequency range
optimally among the connected loudspeakers. This setting is not necessary
when a subwoofer is connected.
SETTINGS
____________________________________________________________________________________
Note:
The following options are available:
»groß« – The loudspeakers are not suited for audio signals under
120 Hz.
»klein« – The loudspeakers are not suited for audio signals under
120 Hz.
8
To conclude the setting, press »
Dolby level
When using Dolby Digital or Dolby Surround ProLogic, all loudspeakers must be
adjusted to the same volume.
1
In the »Speaker configuration« menu, select the »Dolby Level« item with
»P+« or »P –« and press »OK« to confirm.
– The menu for setting the loudspeaker volume appears.
You will hear a hissing sound from the loudspeakers (= test signal).
2
Adjust the volume with » « or » «.
– The cursor indicates which loudspeakers are presently emitting the test
signal. As long as the cursor is against a white background, the volume of
the loudspeaker in question can be adjusted.
The hissing is emitted from the connected loudspeakers in the following
order:
»Volume« – Volume of hissing;
»F balance« – Balance between the left and right front loudspeakers;
»Center« – Volume of the center loudspeaker;
»Subwoofer« – Volume of the subwoofer;
»Rear« – Volume of the surround loudspeakers;
»S balance« – Balance between the left and right surround loudspeakers.
F
3 Press » « (blue) to conclude the setting.
– No surround loudspeakers.
– The built-in subwoofer is used.
»P +« or »P –« and press »OK« to confirm.
»P +« or »P –« and press »OK« to confirm.
F
« (blue) twice.
DIGI 100
19
GRUNDIG Service