Grundig LENARO 92 MFW 92-6110/9 DVD Service Anleitung Seite 24

Allgemeiner Teil / General Section
Active loudspeakers
L
L
CENTER
FRONT
L R
SURROUND
R
L
CENTER SUBWOOFER
LFE
I E
DIGITAL OUT
S
DIGITAL IN
COAX / OPTICAL
WT 2
Passive loudspeakers
12
1 - 24
CONNECTION AND PREPARATION
Connecting external loudspeakers
External loudspeakers which correspond to the required Dolby operating mode
must be connected.
FRONT
Either passive or active loudspeakers can be connected.
R
Passive loudspeakers are connected to the terminal sockets, active loudspeakers
SURROUND
to the cinch sockets.
R
SUBWOOFER
1
LFE Connect Surround loudspeakers to the
2 Connect the center loudspeaker to the »CENTER« socket.
Instead of an external center loudspeaker, it is also possible to use the built-in
front loudspeaker of the television as a center loudspeaker. In this case,
external front loudspeakers must be connected.
3
Connect front loudspeakers to the
4
Connect the subwoofer to the
When connecting a passive sub-woofer, you must place the jumper next to
the terminal socket in the »E« position.
Notes:
I E
To insert the speaker cable, press the spring button on the terminal.
Insert the »–« wire of the cable into the black (–) terminal. Insert the »+« wire
(marked or coloured wire) of the cable into the red terminal.
S
The connected loudspeaker must be adjusted in the EASY DIALOG System in
the »Installation/Speaker configuration« menu.
Instead of active loudspeakers, it is also possible to connect your own output
amplifier with passive loudspeakers.
CONNECTION AND PREPARATION
Connecting AV devices
(video recorder, decoder etc.)
The devices to be connected must be selected in the »Installation« menu
under the menu item »Devices«.
For operation of the Easy Dialog System, see page 16 onwards.
If your video recorder is equipped with Megalogic functions, it must be
connected to the »AV 1« socket with the supplied EURO-AV cable.
For Dolby Digital operation with external playback devices (digital satellite
receivers, digital video recorders, etc.), the digital audio output of this
playback device must be connected to the
television set with an optical cable * or coax cable .
The device must be assigned to the corresponding AV socket in the »Instal-
lation/Devices« menu under menu item »Manual AV settings/Digital audio
input for«.
Note
If the television has been fitted with a digital SAT module (accessories), no
additional digital playback device can be connected to the
socket.
* We recommend FREITAG Electronic optical cables
(order nos. 0426141006 – 1 m long, 0426141008 – 2 m long,
0426141010 – 3 m long)
_______________________________________
»SURROUND L R« sockets.
»FRONT L R« sockets.
»SUBWOOFER LFE« sockets.
_______________________________________
»DIGITAL IN« socket on the
»DIGITAL
DIGI 100
IN«
13
GRUNDIG Service