Safety Precautions; Before Starting The Test Run; Installing The Interface Unit - Mitsubishi Electric PAC-IF011B-E Installationshandbuch

1. Safety precautions

1.4. Before starting the test run

Caution:
• Turn on the main power switch of the outdoor unit more than 12 hours
before starting operation. Starting operation immediately after turning on
the power switch can severely damage the internal parts. Keep the main
power switch turned on during the operation period.

2. Installing the interface unit

Fig. 2-1
B
336
11.5 313
TB142
3-ELECTRIC WIRE INLET
When installed on a wall: Lower side
Fig.2-2
Photo.2-1
A
(11.5)
TB6
TB141
• Before starting operation, check that all protective parts are correctly in-
stalled. Make sure not to get injured by touching high voltage parts.
• Do not touch any switch with wet hands. There may be a risk to get an
electric shock.
• After stopping operation, make sure to wait at least 5 minutes before turn-
ing off the main power. Otherwise, it may cause breakdown.
2.1. Check the parts (Fig. 2-1)
The interface unit should be supplied with the following parts.
Part Name
Interface unit
1
Thermistor
2
2.2. Choosing the interface unit installation location
• Do not install the interface unit in outdoor location as it is designed for indoor
installation only. (It is not waterproof against raindrop.)
• Avoid locations where the unit is exposed to direct sunlight or other sources of
heat.
• Select a location where easy wiring access to the power source is available.
• Avoid locations where combustible gases may leak, be produced, flow, or accu-
mulate.
• Select a level location that can bear the weight and vibration of the unit.
• Avoid locations where the unit is exposed to oil, steam, or sulfuric gas.
2.3. Installing the interface unit (Fig. 2-2, Photo.2-1)
1. Remove 2 screws from interface unit and remove the cover.
2. Install the 4 screws (locally supplied) in 4 holes.
A Screw B Cover
C Hole for installation
Unit:mm
69
Q'ty
1
2