Operation; Menu Structure - Eurolite Smd Pro 132 Dmx Rgb Bedienungsanleitung

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board or in DMX-controlled mode via any commercial DMX controller.

Menu structure

The Control Board offers several features: you can simply set the starting address or run the pre-
programmed program.
The main menu is accessed by pressing Menu until the display is lit. Browse through the menu by pressing
Up or Down. Press Enter in order to select the desired menu. You can change the selection by pressing Up
or Down. Press Enter in order to confirm. You can leave every mode by pressing Menu. The functions
provided are described in the following sections.
Menu Sub menu
A001 A001-A512
C000
CMXX
JU00
FA00
AUTO
SLAV
SOUN
XCHX
DMX starting address setting
Color mix
Dimmer intensity of red LED color 00-99
C1.XX
C100-C101 no red, C102-C199 increasing
Dimmer intensity of green LED color 00-99
C2.CC
C200-C201 no green, C202-C299 increasing
Dimmer intensity of blue LED color 00-99
C3.XX
C300-C301 no blue, C302-C399 increasing
Strobe effect 00-99
CF.XX
CF00 no strobe effect, CF01 (1 Hz) - CF99 (30 Hz) increasing
Preset colors
CM01 Red
CM02 Amber
CM03 Warm yellow
CM.XX CM04 Yellow
CM05 Green
CM06 Turquoise
CM07 Cyan
CM08 Blue
Switching colors
JU.XX
JU00-JU99 with increasing speed
Strobe effect switching colors
JF.XX
JF00 no strobe effect, JF01 (1 Hz) - JF99 (30 Hz) increasing
Fading colors
FA.XX
FA00-FA99 with increasing speed
Strobe effect fading colors
FF.XX
FF00 no strobe effect, FF01 (1 Hz) - FF99 (30 Hz) increasing
Automatic mode/internal program
AU.XX
AU00-AU99 with increasing speed
Slave mode
Sound control/internal program
S0.XX
SO00-SO99 with increasing microphone sensitivity
Setting the DMX channel mode
1CH – 1 channel mode with white strobe effect
2CH1 – 2 channel mode with preset colors
2CH2 – 2 channel mode with white strobe effect
X.CHX 3CH1 – 3 channel mode with white strobe effect
3CH2 – 3 channel mode with preset colors and strobe effect
3CH3 – 3 channel mode, RGB
4CH – 4 channel mode
6CH – 6 channel mode
Function
CM09 Lavender
CM10 Mauve
CM11 Magenta
CM12 Pink
CM13 Warm white
CM14 White
CM15 Cold White
22/32 00113867.DOCX, Version 1.0