Dometic PERFECTPOWER PP1002 Montage- Und Bedienungsanleitung Seite 14

Fastening and connecting the inverter
!
WARNING! Danger of electrocution!
If you wish to connect more than one consumer to the inverter and install
a socket distributor loop, you must arrange a circuit breaker (residual
current circuit breaker) and set a grounding bridge in the inverter, see
chapter "Connecting multiple consumers" on page 15.
Earthing the inverter
➤ Connect the earth connection on the inverter (fig. 2 4, page 3) with the earth of
the vehicle.
Connecting the inverter to the battery
I
NOTE
Please be aware that all volatile memories of the connected electric con-
sumers will lose their stored data if the battery is disconnected.
A
NOTICE!
Make sure the polarity is correct. If the positive and negative
connections are reversed, this may damage the device.
➤ Connect the terminal on the red battery connection cable to the positive terminal
(fig. 2 7, page 3) on the inverter.
➤ Connect the terminal on the black battery connection cable to the negative
terminal (fig. 2 6, page 3) on the inverter.
➤ Check the connections are secure.
You might have to tighten the screws again later.
I
NOTE
Sparks may be produced when the connections are made due to the
internal capacitors being charged.
➤ Connect the red battery connection cable to the positive terminal on the battery.
➤ Connect the black battery connection cable to the negative terminal on the
battery.
14
PerfectPower
EN