Dry Vacuuming - Cocraft PRO WS30-A Bedienungsanleitung

Switching on a power tool connected to the socket automatically switches on the vacuum
cleaner; switching the connected tool off, switches off the vacuum cleaner.
1. Plug a circular saw or similar power tool into the onboard power socket.
2. Then connect the suction hose (2) from the vacuum cleaner to the dust extractor port on
the circular saw (or respective power tool). Set the power switch to the AUTO position.
3. The on and off switchings of the vacuum cleaner will now be controlled by
the connected power tool. The vacuum cleaner will be switched on as soon as
the connected power tool is switched on. When the connected power tool is switched
off there will be about a 5-second delay before the vacuum cleaner is switched off.
Note: The power tool socket must not be loaded with more than 2180 W.

Dry vacuuming

1
5
9
1. Make sure that the vacuum is unplugged from the mains.
2. Fit the cartridge filter onto the bottom of the motor unit.
3. Secure the cartridge filter in place by turning the filter retainer clockwise.
4. Pass the pre-filter over the cartridge filter so that it completely encapsulates it.
5. Fit the dust bag.
6. Refit the motor unit onto the container and fasten it on using the toggle catches.
7. Attach the suction hose to the container by screwing it onto the vacuum port.
8. Attach the appropriate accessory.
9. Plug the mains lead into a wall socket.
10. Switch the vacuum cleaner on by setting the power switch to the desired setting.
2
6
10
7
3
7
4
8