1. Make sure that the vacuum is unplugged from the mains.
2. Open the toggle catches.
3. Lift up the motor unit and remove the accessories from the container.
4. Check that all the parts are intact and that nothing is missing.
5. Press the castors securely into the underside of the container.
6. Assemble the wheels as follows:
-
Insert the wheel axle into the rear support block.
-
Pass a washer over each end of the axle.
-
Fit the wheels onto the axle.
-
Fit a washer outside the wheels on each end of the axle.
-
Secure the washers with the spring cotter pins.
-
Fit the hub caps.
Operating instructions
•
Warning: Read all the warnings and safety instructions in the manual before use.
•
Warning: Always unplug the mains lead from the wall socket before any
maintenance or adjustments.
•
Note: The cartridge filter (8) is for vacuuming dust. The foam filter (11) must only
be used for vacuuming water.
•
When very fine-particled substances are to be vacuumed, the filter cartridge,
pre-filter (3) and the dust bag must be used.
Switching on/off
Power switch
The power switch has three settings:
•
I On
•
0 Off
•
AUTO Power tool socket energized, automatic on/off switching of the vacuum cleaner.
Power tool socket
6