Wet Vacuuming - Cocraft PRO WS30-A Bedienungsanleitung

Wet vacuuming

Note: Do not submerge the entire nozzle under the surface of the liquid. Leave some
space so that air can also pass through when vacuuming a large amount of liquid.
1
5
1. Make sure that the vacuum is unplugged from the mains.
2. Remove the motor unit and fit the foam filter. Refit the motor unit onto
the container and fasten it on using the toggle catches.
3. Attach the suction hose to the container by screwing it onto the vacuum port.
4. Attach the appropriate accessory.
5. Plug the mains lead into a wall socket.
6. Start the vacuum with the power switch.
7. Empty the container when it becomes full (see below).
Things to consider when wet vacuuming
• The cloth bag pre-filter, cartridge filter and dust bag must first be removed and
the foam filter fitted, before beginning any type of wet vacuuming.
• Make sure that the foam filter is clean and dry before fitting it onto the motor unit
and beginning to wet-vacuum.
• The water level within the container is regulated by a safety float valve.
When the container needs to be emptied, the safety valve stops suction and
the motor will race. Turn off the motor with the power switch, remove the drain cap
(32) and empty the container.
• Clean the foam filter regularly. Remove the foam filter and hand wash it with water
and a little mild detergent. Allow the filter to air dry.
• Wipe the container clean and allow it to dry before storing the vacuum or
continuing with any type of dry vacuuming.
• Don't forget to fit the cartridge filter, pre-filter and dust bag before beginning any
type of dry vacuuming.
2
6
8
3 4
7