Yamaha D24 Aktualisierung Und Betriebsanleitung Seite 6

6
Assigning Virtual Tracks Using SOLO & Keypad
When assigning virtual tracks to main tracks, the SOLO/SELECT buttons can now be
used to select the main track. (Previously, only the SHUTTLE/CURSOR could be used
for this.) In addition, the number keypad can now be used to select virtual tracks. (Pre-
viously, only the JOG/DATA dial could be used for this.)
While the D24 is stopped, press the [V. TRACK SELECT] button.
1
The V. TRACK SELECT indicator lights up.
The 1st line of the display shows the main track numbers from 1 through 8. The 2nd
line shows the virtual tracks assigned to those main tracks. Initially, each main track is
assigned its respective virtual track 1.
Use the SOLO/SELECT buttons or SHUTTLE/CURSOR ring to select a main
2
track.
The number of the virtual track assigned to the selected main track flashes on the 2nd
line of the display and the corresponding SOLO/SELECT indicator lights up.
Use the number keypad or JOG/DATA dial to assign a virtual track to the
3
selected main track.
Press the [ENTER] button to apply your virtual track settings.
4
"FINISHED" appears on the display for a few seconds and then The V. TRACK SELECT
indicator goes out.
Functions Echoed Across Multiple D24s
In a multiple-unit system, the following settings made on the master D24 are echoed by
the slave D24s. (Previously, these settings were not echoed by the slaves.)
• Setting the A, B, LAST REC IN and OUT points.
• Canceling the A, B, LAST REC IN and OUT points.
• LAST REC IN and OUT points for auto punch in/out recording.
• Setting the LEVEL METER mode—NORMAL or FINE.
Settings other than LEVEL METER mode also work on the remote controller.
Fixing Take 00
When using the Fix Take function to select the take you want to keep after auto punch
in/out recording, the original material (i.e., TAKE 00) can now be selected. (Previously,
TAKE 00 could not be selected, so to revert to the original material you had to fix
another take, exit the Auto Punch function, and then use Undo.) As before, the original
material (i.e., TAKE 00) can be auditioned by using the Audition Take function.
Fix Take cannot be performed from the remote controller or in a multiple-unit system.
Remote ID Conflict Error Message
In a multiple-unit system, if two or more D24s are assigned the same Remote ID, the
error message "RMT ID ERROR" appears when the [CHASE] button is pressed, and
Chase mode cannot be engaged.
D24—Version 2.0 Supplement