Operating Elements; Initial Power-Up - HEIDENHAIN ND 500 Installationsanleitung

ND 500
Installation Instructions
Complete Operating Instructions available at www.heidenhain.de
Data interface connections
Notice
This product contains components that can be damaged by electrostatic
discharge (ESD). Observe precautions for handling ESD sensitive devices and
never touch connector pins unless properly grounded.
Connecting an encoder
This product can be used with HEIDENHAIN linear, and rotary encoders that provide
digital TTL level signals. The connecting cable must not exceed 30 meters in length.
To connect an encoder:
Verify that the power switch is in the off position.
X X
Connect the axis encoder tightly to it's connector. An input designator is provided near
X X
each connector located on the rear of the product.
Connecting a USB cable
The USB port is used to communicate with a computer. For more information on USB
communications, refer to the ND 500 Operating Instructions .
To connect a USB cable:
Verify that the power switch is in the off position.
X X
Connect a computer USB port to the products USB port located on the rear of the
X X
product, using a USB (type A) to USB (type B) cable.

7. Operating elements

Front
LCD screen
A
Soft keys: Change to support
B
functions
Axis keys: Zero or preset datums
C
Numeric keypad: Enter numeric
D
data

8. Initial power-up

To power-up the product:
Press the On (supply) side of the power switch 1 to power-up the product.
X X
The startup screen is displayed.
Front (cont)
Arrow keys: Menu navigation
E
Hard key functions: Specific to
F
milling, or turning functions
Power indicator light: LED is
G
illuminated when power is on
Observe ESD handling precautions
5
X1, X2, X3 - « TTL
4
USB (type B)
11