Detachable Display - VOLTCRAFT BS-200XW Bedienungsanleitung

1. Press the on/off button to switch the device on. The power LED will turn on and the camera
image will appear in the monitor.
2. Two LEDs are integrated in the camera head.
- Press the button ↑ to increase the brightness of the LEDs.
- Press the button ↓ to reduce the brightness of the LEDs or to turn the lighting off entirely.
Set the lighting so that the camera image displayed is neither overexposed nor
underexposed.
3. Press the buttons ↑ and ↓ simultaneously to rotate the image by 180º.
Attachments
1. If required, mount one of the three attachments (magnet, hook, mirror) into the small recess
1. below the camera head.
2. Before use, ensure that the mounting ring of the attachment is locked.
Ring bolt
There is a ring bolt fitted above the monitor. Attach this bolt to a carrying strap (not included), if
required, to facilitate hands-free operation.

10. Detachable display

You can detach the display from the endoscope, if required. The camera picture will then be
transmitted via the monitor cable to the display. For this, proceed as follows:
1. Slide the display upwards, toward the gooseneck, and remove the display.
2. Connect the micro USB plug of the monitor cable to the matching connection on the left side
of the display unit.
3. Connect the monitor cable's mini USB plug to the matching connection on the endoscope.
This connection can be found where previously the display was attached.
4. Now turn the endoscope on. The camera picture appears on the display.
21