Natural Mode (In Tile Mode) (Command : D J); Dpm Select (Command: F J); Temperature Value (Command: D N); Remote Controller Lock/ Key Lock (Command: K M) - HP LD5535 Benutzerhandbuch

[h][ ][Set ID][ ][OK/NG][Data][x]

32. Natural Mode (In Tile Mode) (Command : d j)

To display the image naturally, the part of the image that would normally be displayed in the gap
between the displays is omitted.
Transmission
[d][j][ ][Set ID][ ][Data][Cr]
Data
00: Off
ff: Read Status
Acknowledgement
[j][ ][Set ID][ ][OK/NG][Data][x]

33. DPM Select (Command: f j)

To set the DPM (Display Power Management) function.
Transmission
[f][j][ ][Set ID][ ][Data][Cr]
Data
00: Off
01: On
Acknowledgement
[j][ ][Set ID][ ][OK/NG][Data][x]

34. Temperature Value (Command: d n)

To check the inside temperature value.
Transmission
[d][n][ ][Set ID][ ][Data][Cr]
Data
FF: Check the status
Acknowledgement
[n][ ][Set ID][ ][OK/NG][Data][x]
* Temperature is displayed in hexadecimal.

35. Remote Controller Lock/ Key Lock (Command: k m)

When the remote control and front keys are locked in standby mode, the power cannot be turned on
using the remote control or front power button.
Transmission
[k][m][ ][Set ID][ ][Data][Cr]
Transmission / Receiving protocol 97