Password Settings - Renkforce MAC-608 Bedienungsanleitung

DIP-switch "T3" alarm output (alarm duration): Time can be set between 5 seconds and 15 minutes (only
alarm zones Z1 and Z7)
Jumper position
OFF
OFF
OFF
OFF
ON
ON
ON
ON
Observe the applicable statutory and community provisions! In Germany, an alarm must not exceed
3 minutes (= 180 seconds). However, this time may differ in certain communities and locations
(e.g. in spa towns).
b) Password Settings
The element "SW1" on the PCB is prepared in the factory to set an individual password for operation of
the alarm system. First set the DUP switches to "SW1" as shown in programming step <1> and change the
password in step <2> via the keypad. Then put all jumpers on "SW1" in the position OFF.
Programming Step Jumper position
<1>
<2>
<3>
UUUU in the table means the new password.
32
OFF
OFF
ON
ON
OFF
OFF
ON
ON
ON OFF
Press * 51234 0 UUUU #
OFF OFF
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
OFF
Time
5 seconds
30 seconds
2 minutes
3 minutes
5 minutes
8 minutes
12 minutes
15 minutes
OFF
OFF