Intended Use - Renkforce MAC-608 Bedienungsanleitung

2. Intended Use

This 8 zone alarm system is perfect to secure apartments, offices and small companies against "small
risks".
It is not suitable for protection from maximum and large risks that are present in large companies, com-
mercial buildings or industrial sites.
The alarm system reports unauthorised entry into the secured building by switching of outputs to which
you can connect visual, acoustic or silent signal encoders.
The alarm system has eight alarm zones, an internal signal encoder and a connection for an optional lead
battery that is available as a separate accessory (12 V DC, 1.2 Ah), to maintain operation even during a
power outage. The lead battery is placed in the alarm system housing.
To operate the system, it must be connected to the main power supply. Operation is possible without the lead
acid battery, but the lead acid battery should also be connected for reasons of safety.
When under operation, the alarm system works entirely through the integrated key switch and the buttons
arranged on the housing, or with the help of an optional external remote switch.
The basic settings can be adjusted with the DIP switches on the PCB after successful installation.
The alarm system is only suitable for dry indoor use. Any use other than the intended use described above
is not permitted and may harm the product and result in short circuit, fire, etc.
The entire product must not be modified or converted. Always observe the safety information included
in these operating instructions. Please read the operating instructions carefully and keep them for later
reference.
It is absolutely essential to protect the alarm system additionally with external sensors (movement alarm,
magnet contacts etc.), so that manipulationsof the alarm system control may be ruled out completely. Sa-
botage loops should be integrated in the wires of the alarm components.
21