Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Testing:
After mounting the sensor, test the sensor by opening and closing the door
or window. The Control Panel should respond in the same way as described
above, "Test Sensor".
Note:
• Try to mount the sensors as far away from the floor as possible to avoid
damaging them. Mounting the sensors at a higher position will also result in
better operating range.
• Do not mount the sensor to exterior of the door / window, always mount the
sensor to the interior side of the door / window to avoid being damaged or
stolen by non-intended users.
4. Operation
Door / Window Sensor is used to monitor doors or windows that open and
close. When these doors / window are open or closed, the sensors will
transmit a signal to the control panel to notify the user.
Refer to the AS-200 Series User`s Instructions for detail information regar-
ding the operation of this door / window sensor with the control panel.
5. Sensor failure ä/ low battery indication
The control panel constantly monitors its sensors, if the control panel fails
to communicate with any senosors, it will begin rapidly flashing the zone
LED indicator.
When sensor failure occurs, try the following:
1. Check if the sensor is located at where it should be, and whether there is
any physical damage to the sensor.
2. If the failed sensor is not physically damaged, try to activate the sensor and
see if the control panel reacts to such activation.
3. If not, try to remove the sensor from its location, and bring it closer to
control panel and activate the sensor.
12
It is possible that the sensor is installed too far from the control panel and it
cannot establish a steady communication with the control panel. If this is
the case, please install the sensor closer to the control panel.
4. Replace the battery of the sensor in that zone if the Control Panel does not
respond when the sensor is activated within short range.
If you have multiple sensors in a zone, you may test the function of each
sensor to identify which sensor is having problem.
Registration and Safety Certification/General Information
This device bears the CE symbol as specified by the provisions of Directive R
& TTE (1999/5/EC).
Hama GmbH & Co. KG hereby declares that this device is in compliance with
the basic requirements and other relevant guidelines and regulations of the
1999/5/EC guideline. You will find the declaration of compliance and declaration
of conformity in the Internet at http://www.hama.com
13
Werbung
