Hama 00104987 Bedienungsanleitung Seite 5

g Operating instruction
1. Introduction
The Door / Window Sensor is designed to monitor any door or window within
your house. It works in conjunction with AS-200 Series Control Panel. When
the monitored window or door is opened, the control panel will either alert
you or alarm will be triggered.
In this package, you should find a sensor, a magnet, 3V Lithium battery and
other mounting accessories.
Magnet
2 pcs 3.5 x 18 screws
Sensor
2 pcs 3.5 x 12 screws
Please follow the instructions below to set up the door / window sensor.
2. Learn sensor to AS-200 Series Control Panel
In order for the sensor to communicate with the control panel properly, the
sensor must be programmed to the control panel. Follow the brief
instructions below or refer to the detail instructions from AS-200 Series.
User`s Instructions to program the sensor to the control panel. Before
proceeding, please remove the battery isolator from the sensor, and placing
the magnet beside the transmitter (where the red marking is).
Step 1:
Press and hold the Learn Button on the Control Panel for 3 seconds. Control
Panel beeps once and you may release the Learn Button.
8
3V Lithium battery
Mounting plate
Press 3 sec.
Step 2:
Press the zone button (1, 2, 3 or 4) once, for which you want to program the
sensor to. The selected Zone LED will flash
Press the zone button
Step 3:
Activate the Door Window Sensor by separating the magnet from sensor unit.
Sensor
Magnet
Long Beep
Zone LED flashing
Separate the magnetic
from the sensor
Control Panel long beep Zone
LED flashing OFF
9