Connections And Controls / Warranty - ELAC MIRACORD 70 Bedienungsanleitung/Sicherheitshinweise

CONNECTIONS / WARRANTY
Connections and controls
Warranty
The terms of warranty are regulated individually by the law in the different countries and by
the terms of the international ELAC representatives respectively. If you have not bought your
appliance in Germany, please check the terms with your retailer. Warranty can be given by any
special retailer who has been authorized by ELAC or the respective international representative
to distribute ELAC products (EU contract retailers). In the case of warranty, the complete appliance
together with the receipt must be handed over to the retailer.
1. Connecting the audio outputs:
The two RCA jacks are directly connected to the pick-
up system. So, you need a (pre-) amplifi er with phono
inputs or an additional phono preamp.
The white RCA jack outputs the left channel; the red
one outputs the right one.
Next to the output jacks, there is the earth connector
which is connected to the metal parts of the turntable.
This screw can be used for potential equalization with
the connected (phono-) preamp. Sometimes it's also
useful for getting rid of humming problems. Preferably
you should use the audio cable (C) which is part of the
accessory kit.
2. Connecting the power supply:
On the rear side of the turntable you can fi nd the power
supply jack. Please connect the power supply adaptor
(E) which comes with the turntable here. The power sup-
ply adaptor should then be plugged into an available
mains receptacle.
3. Turning on the motor:
Switch the motor on or off by means of the switch at the
front.
15