Preparation For Operation - ELAC MIRACORD 70 Bedienungsanleitung/Sicherheitshinweise

PREPARATION FOR OPERATION

Before the turntable can be used, some preliminary activities must be put into effect.
1. How to install the belt:
Get the belt from the packaging and put it around the
sub platter. Now pull the belt in direction of the motor
and pull it over the motor pulley. To make sure the belt
is running properly, rotate the sub platter clockwise with
one hand and guide the belt to the right position. That
should be the case after a couple of revolutions.
Remark:
For a rotation speed of 33 ⅓ rpm please choose the
smaller diameter of the pulley; for a rotation speed of
45 rpm please choose the larger diameter.
Move the belt into the correct position
Belt put on properly
Belt put on incorrectly
2. How to install the platter (B):
The platter (B) must be positioned in perfect alignment
to the sub platter. Settle down the platter carefully,
without tilting it. The platter should lie fl ush on all 4
rubber bumpers of the sub platter. Turn the platter
clockwise carefully to see if there's no radial runout.
13