Controls Layout - babymoov High Care Bedienungsanleitung

2. Operation using the (AC adapter supplied)
The transmitter can be operated on AC mains using
the supplied 6V AC adapter. Connect the output
plug of adapter to DC jack (7a) of the transmitter.
Connect the adapter to the mains. The power
supply from the battery will be cut off once the
receiver is mains-operating.
N.B.: The communication range is longest when the
transmitter is operated on AC mains.
B / Receiver
1. Operation from battery pack
The Li polymer battery pack is already installed in
the unit.
2. Recharging and operation on the base
Before using the receiver for the first time, make
sure it is turned off and recharge it on its base. The
charge indicator will show a red light. Once the
battery is fully charged (average time 3 hours) the
indicator will turn green. The receiver is then ready
to be turned on and used. If you decide to leave the
receiver on its base, when it detects that the charge
level is too low the base will automatically start
recharging the battery.
N.B.: TO ENSURE MAXIMUM LIFE FOR YOUR
BATTERY, WAIT UNTIL IT IS COMPLETELY
DISCHARGED BEFORE RECHARGING IT.

CONTROLS LAYOUT

Transmitter
1. Power ON/OFF and night light switch
2. Up/Down button
3. Mode button
4. Night light
5. Microphone
6. Power on indicator
7a. DC jack
7b. Temperature sensor
Charger
14. Charging indicator
15. Charging pins
16. DC jack
Receiver LCD Screen
Lower Temperature Limit
Upper Temperature Limit
Channel NO./
Baby's Room Temperature
Battery Status Indicator
12
BABYPHONE HIGH CARE • Instruction Manual
1
2
Receiver
8. Power ON/OFF and vibration switch
9. Up/Down button
10. Mode button
11. LED sound level meter
12. Speaker
13. Charging contacts
Out-of-range Icon
Vibration Icon
Transmitter Battery Low Icon
Digital Code
Speaker Volume Bar Graph
Transmitter LCD Screen
Night Light VOX Icon
Night Light Icon
Channel NO./
Baby's Room Temperature
Battery Status Indicator
TRANSMITTOR
Press and hold the mode button (3) for
Channel and
digital code more than 5 seconds ; a beep will sound
setting once the unit goes into programming
mode. The LCD will show following:
Use selection button (2) to chose the
channel and press the mode button (3) to
validate your choice. The LCD will show
following (here CH 2 is selected):
Use selection button (2) to chose the digital
code and press the mode button (3) to
validate your choice. The LCD will show
following (here digital code 28 is selected):
Use selection button (2) to chose the
Output power
output power output. Hi means high
setting
power while Lo means low power and ELo
means extra low power. Press the mode
button (3) to validate your choice.
BABYPHONE HIGH CARE • Instruction Manual
Transmit Icon
Range Check Icon
Digital Code
Microphone Sensitivity Bar Graph
SETTINGS
RECEIVER
Press and hold the mode button (10) for
more than 5 seconds ; a beep will sound
once the unit goes into programming
mode. The LCD will show following:
Use selection button (9) to select the same
channel as on the transmitter and press
the mode button (10) to validate your
choice. The LCD will show following (here
CH 2 is selected):
Use selection button (9) to select the same
digital code as on the transmitter and press
the mode button (10) to validate your choice.
The LCD will show following (digital code
28 is selected):
13