Electromagnetic Fields (Emf); Mains Operation - Philips SCD530 Bedienungsanleitung

EngliSh
8
- Make sure the baby unit and the cord are always out of reach of the baby (at least 1 metre/3
feet away).
- Never place the baby unit inside the baby's bed or playpen.
- Never cover the parent unit and the baby unit with anything (e.g. a towel or blanket). Always
make sure the cooling vents of the baby unit are free.
- Always place non-recheargeable batteries of the correct type in the baby unit.
- Always use the included rechargeable battery pack for the parent unit to avoid a hazard.
- If you place the parent unit next to a transmitter or other DECT appliance (e.g. a DECT
telephone), the connection with the baby unit may be lost.
general
- This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult
supervision and should not be used as such.
- The humidity and temperature sensor only measures the temperature and humidity in the baby
room. It cannot be used to control or adjust the temperature and humidity in the baby room.

Electromagnetic fields (EMF)

This Philips AVENT appliance complies with all standards regarding electromagnetic fields (EMF). If
handled properly and according to the instructions in this user manual, the appliance is safe to use
based on scientific evidence available today.
preparing for use
Baby unit
You can use the baby unit from the mains or on non-rechargeable batteries. Even if you are going to
use the unit from the mains, we advise you to insert non-rechargeable batteries. This guarantees
automatic back-up in case of mains failure.

mains operation

1 Put the large appliance plug in the baby unit and put the adapter in a wall socket (Fig. 2).
The power-on light goes on.
,
operation on non-rechargeable batteries
The baby unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use
Philips LR6 PowerLife batteries.
Do not use rechargeable batteries, as the baby unit does not have a charging function.
Unplug the baby unit and make sure your hands and the unit are dry when you insert the non-
rechargeable batteries.
1 Remove the lid of the compartment for non-rechargeable batteries. (Fig. 3)
2 Insert four non-rechargeable batteries (Fig. 4).
Note: Make sure the + and - poles point in the right direction.
3 Reattach the lid. (Fig. 5)
parent unit
operation on rechargeable battery pack
The parent unit comes with a rechargeable Li-ion 1000mAh battery pack.
Charge the parent unit before you use it for the first time or when the parent unit indicates that the
battery is low (the empty battery symbol flashes on the display and the parent unit beeps). The
parent unit starts indicating that the battery pack is low 30 minutes before the battery pack is
completely empty.