Electromagnetic Fields (Emf); Preparing For Use; Baby Unit; Mains Operation - Philips SCD510 Bedienungsanleitung

EngliSh
8
- Dispose of non-rechargeable batteries and rechargeable batteries properly (see chapter
'Environment').

Electromagnetic fields (EMF)

This Philips AVENT appliance complies with all standards regarding electromagnetic fields (EMF). If
handled properly and according to the instructions in this user manual, the appliance is safe to use
based on scientific evidence available today.

preparing for use

Baby unit

You can use the baby unit from the mains or on non-rechargeable batteries. Even if you are going to
use the unit from the mains, we advise you to insert the non-rechargeable batteries. This guarantees
automatic back-up in case of mains failure.

mains operation

1 Put the large appliance plug in the baby unit and put the adapter in a wall socket (Fig. 2).
The power-on light goes on.
,
operation on non-rechargeable batteries
The baby unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use
Philips LR6 PowerLife batteries.
Do not use rechargeable batteries, as the baby unit does not have a charging function.
Unplug the baby unit and make sure your hands and the unit are dry when you insert the non-
rechargeable batteries.
1 Remove the lid of the compartment for non-rechargeable batteries. (Fig. 3)
2 Insert four non-rechargeable batteries (Fig. 4).
Note: Make sure the + and - poles point in the right direction.
3 Reattach the lid. (Fig. 5)
Note: When the batteries are low, the battery light on the baby unit flashes red.
parent unit
operation on rechargeable batteries
The parent unit comes with two NiMH AAA 850mAh batteries.
Charge the parent unit before you use it for the first time or when the battery light indicates that
the batteries are low. The battery light flashes red when the batteries are low. The battery light starts
to flash red 30 minutes before the batteries are completely empty.
Note: If the batteries are completely empty, the parent unit automatically switches off and loses contact
with the baby unit.
1 Remove the lid of the compartment for the rechargeable batteries (Fig. 6).
2 Insert the rechargeable batteries (Fig. 7).
Note: Make sure the + and - poles of the batteries point in the right direction.
3 Reattach the lid (Fig. 8).
4 Put the small appliance plug in the parent unit and put the adapter in a wall socket (Fig. 9).
5 Leave the parent unit connected to the mains until the batteries are fully charged.
During charging, the battery light lights up red continuously.
,
When the batteries are fully charged, the battery light lights up green continuously.
,