Cleaning And Maintenance - Philips SCD535 Bedienungsanleitung

EngliSh
18
Connecting the neck strap
1 Insert the end loop of the neck strap through the hole behind the strap post. Thread the
neck strap through the end loop and pull the neck strap tight (Fig. 34).
Disconnecting the neck strap
1 Pass the neck strip through the end loop and pull the end loop out of the hole behind the
strap post.

Cleaning and maintenance

Do not immerse the parent unit or the baby unit in water and do not clean them under the tap.
Do not use cleaning spray or liquid cleaners.
1 Unplug the baby unit if it is connected to the mains and take the parent unit out of the
charger.
2 Clean the parent unit and the baby unit with a damp cloth.
Make sure the parent unit is dry before you put it back into the plugged-in charger.
3 Clean the charger with a dry cloth.
4 Clean the adapters with a dry cloth.
Storage
- You can use the travel pouch to store the baby monitor while you travel.
- When you are not going to use the baby monitor for some time, remove the non-rechargeable
batteries from the baby unit and remove the rechargeable battery pack from the parent unit.
Store the parent unit, the baby unit, the charger of the parent unit and the adapters in the travel
pouch supplied.
replacement
Baby unit
Batteries
Only replace the non-rechargeable batteries of the baby unit with four 1.5V R6 AA batteries.
Note: We strongly advise you to use Philips non-rechargeable batteries.
adapter
Only replace the adapter of the baby unit with an adapter of the original type.You can order a new
adapter from your dealer or a Philips service centre.
- UK only: S004LB0750040 (UK)
- Other countries: S004LV0750050 (EU)
parent unit
Battery pack
Only replace the battery pack of the parent unit with a Li-ion 1000mAh battery pack.
adapter
Only replace the adapter of the parent unit charger with an adapter of the original type. You can
order a new adapter from your dealer or a Philips service centre.
- UK only: S004LB0750050 (UK)
- Other countries: S004LV0750050 (EU)